Gladiator Garageworks 2253210A Complete the Assembly, Lower Front Corner, Lower Rear Corner

2.Place the plastic skids (shipped with the convertible refrigerator/ freezer) on the floor at least 3 ft. (91.44 cm) apart. Lay a piece of cardboard or other protective material over the skids. This will elevate the convertible refrigerator/freezer to allow for easier caster installation and also protect it from scratches.

NOTE: If the skids have been discarded or are not available, 2" x 4" boards may be used.

3.Place the convertible refrigerator/freezer on its side on top of the cardboard or protective material. Make sure the door hinge is facing upward.

IMPORTANT: It is important that the door hinge face upward during the entire caster installation.

A

B

A. Top Hinge

B. Center Hinge

4.Remove the caster and fasteners from the box.

5.Locate and remove the caster brackets from the FeaturePak.

6.Using ⁵⁄₁₆–18 hex-head bolts, attach 1 rigid caster and 1 swivel caster to each caster bracket. The rigid caster fits the front of the bracket, and the swivel caster fits on the rear.

7.Insert the hex-head bolts from the bottom and start the self- locking nuts for each caster.

	A
	B
	C
	D
A. Self-locking nut	C. ⁵⁄₁₆–18 x ⁷⁄₈" hex-head bolt
B. Caster bracket	D. Caster

8.Hold the head of the hex-head bolt with a wrench while tightening the self-locking nuts with a socket wrench.

9.Using a ¹⁄₂" socket wrench, remove the 4 unit bolts (2 on each side) from the lower front and rear of the convertible refrigerator/ freezer.

NOTE: Do not remove the leveling bolt.

Lower Front Corner

A

B

A. Leveling bolt (do not remove)

B. Unit bolt

10.Place the slot in the rear of the caster bracket over the hole in the rear of the convertible refrigerator/freezer. Align the hole in the front of the caster bracket with the hole in the front of the convertible refrigerator/freezer.

Lower Rear Corner

A

B

A. Rear convertible refrigerator/freezer hole

B. Caster bracket

11.Hold the bracket in place and insert the unit bolts into the front and rear unit holes and tighten.

NOTE: Do not overtighten the bolts.

12.Insert 2 of the ¹⁄₄–20 x 1 ¹⁄₄" hex-head bolts and lock washers into the 2 caster bracket holes in the side as shown. Push the caster bracket against the bottom of the convertible refrigerator/freezer and tighten the bolts using a ³⁄₈" socket wrench.

A

A. Caster bracket holes

13.Repeat steps 10 – 12 for the second caster bracket.

Complete the Assembly

1.Lock the front caster.

NOTE: Locking the casters will help prevent the convertible refrigerator/freezer from moving while it is being lifted.

2.Insert a small piece of cardboard between the caster brake and the floor. This will help prevent the brake from rubbing on the floor.

3.Stand the convertible refrigerator/freezer upright.

4.Replace the base grille by placing the metal clips in the openings in the metal panel and rolling the grille downward until it snaps into place.

5.Unlock the casters and move the convertible refrigerator/freezer into its desired location.

6.After the convertible refrigerator/freezer is in position, lock the casters again.

3