Install the Casters

(optional)

WARNING

Excessive Weight Hazard

Use two or more people to move and assemble shelving.

Failure to do so can result in back or other injury.

1.Lay the welded end frames down.

2.Insert the caster bolt into the hole.

3.Thread a self-locking nut onto the bolt

4.Using the wrench provided, hold the caster firmly in place.

5.Using a ³⁄₄ in. socket wrench, tighten the self-locking nut.

6.Press the attached metal brake lever to lock the wheel.

7.Repeat this process for the 3 remaining casters.

1

2

3

1.Caster bolt hole

2.Self-locking nut (on bolt)

3.Metal brake lever

Install the Rails

IMPORTANT:

When you are using all 3 shelves, the first shelf must be installed in the bottom 6 in. (15.24 cm) of the frame.

If you are using only 2 shelves, one rail must be attached to the bottom holes at the rear of the frame for support.

To ensure level shelves, you must count and mark the placement holes accurately on each side before installing the rails.

1.Determine the desired shelf height and spacing.

2.Mark the corresponding holes on all sides of the frame.

3.With the locking tabs to the outside, attach one rail to the holes in the frame front.

1

2

1.Rail locking tab

2.End plate

4.With the locking tabs to the outside, attach the other rail to the holes in the frame back.

5.Using a rubber mallet, pound down on the top of each rail to seat it firmly in the frame. Make sure the rail locking tab is engaged. You will hear a click, and the tab will be flat against the face of the end plate.

4

Page 4
Image 4
Gladiator Garageworks 2253351A manual Install the Casters, Install the Rails