ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply.

Rating label is on the left hand side of fridge inner liner.

We recommend that this appliance is connected to the mains supply via a suitable switched and fused socket in a readily accessible position. Should the mains lead of the appliance become damaged or should it need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a (0171-.0 Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers can be obtained from a ellin authorised service agent.

IMPORTANT! FITTING A DIFFERENT PLUG

As the colours of the wires in the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

mains lead of this appliance may

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

not correspond with the coloured

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

markings identifying the terminals

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

in your plug proceed as follows:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(See diagram).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1. Connect the green-yellow or

GREEN &

 

 

 

 

 

 

 

 

 

 

YELLOW

 

 

 

 

 

 

 

 

green (Earth) wire to the terminal

 

 

 

OR

 

 

 

 

 

 

 

 

in the plug marked 'E' or with

 

 

 

GREEN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BROWN

V)

 

 

 

 

 

 

 

 

 

 

 

 

OR

 

 

 

 

 

the symbol 0 or coloured

 

 

 

N

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

RED

 

 

ti

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BLUE

 

 

 

 

 

 

 

 

green and yellow or green.

 

 

OR

 

 

 

 

 

 

 

 

 

 

BLACK

 

 

 

 

 

 

 

 

 

2. Connect the blue (Neutral) wire

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CD

 

to the terminal in the plug

 

 

 

 

 

 

 

O CORD GRIP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

marked 'N' or coloured black.

 

 

 

 

 

C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3.Connect the brown (Live) wire to the terminal in the plug marked 'L' or coloured red.

With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.

3

Page 5
Image 5
Glen Dimplex Home Appliances Ltd BE815 manual Electrical Requirements, IMPORTANT! Fitting a Different Plug