8.Use safety accessories. Safety glasses and earmuffs should always be worn. A face or dust mask is required if the cutting operation creates dust.
9.Do not abuse the power cord. Never pull the cord to disconnect the tool from the power point. Keep the cord away from heat, oil and sharp edges.
10.Secure the workpiece. Use clamps or a vice to hold the workpiece. It is safer than using your hand and frees both hands to operate the tool.
11.Do not overreach. Keep your footing secure and balanced at all times.
12.Look after your tools. Keep tools sharp and clean for better and safer performance. Follow the instructions regarding lubrication and accessory changes. Inspect tool cords periodically and, if damaged, have them repaired by an authorised service facility. Inspect extension cords periodically and replace them if damaged. Keep tool handles dry, clean and free from oil and grease.
13.Disconnect idle tools. Switch off the power and disconnect the plug from the power point before servicing, when changing accessories such as blades, bits and cutters, and when the tool is not in use.
14.Remove adjusting keys and wrenches. Get into the habit of always checking to see that keys and adjusting wrenches are removed from the tool before switching on.
15.Avoid unintentional starting. Always check that the switch is in the OFF position before plugging in the tool to the power supply.
16.Use outdoor rated extension cords. When a tool is used outdoors, use only extension cords that are intended for outdoor use and are so marked.
17.Stay alert. Watch what you are doing. Use common sense. Do not operate a power tool when you are tired.
18.Check for damaged parts. Before using a tool, check that there are no damaged parts. If a part, such as a guard is damaged, carefully determine if it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A
guard or other part that is damaged should be properly repaired or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly.
19.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, ranges and refrigerator enclosures.
20.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.
21.Warning. The use of any accessory or attachment other than those recommended in this instruction manual, may present a risk of personal injury.
22.Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repair should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user.
23.Special safety hints.
•Your cordless drill is not charged when purchased. Be sure to charge the unit for fully approximately
•A battery stored used or charged under high temperature conditions will deteriorate more quickly.
•Don’t overcharge the battery.
•Once your battery is fully charged, disconnect the charger from the power and store safely in the drill.
•Never store the battery out of the drill, as the two contacts on the drill are exposed and could be shorted by a metal object and cause a fire or explosion!
•Before drilling check that there are no hidden hazards such as electric cables, water or gas pipes running below the
•Don’t expose either the drill or charger to rain, high humidity or wet conditions.
4
