Assembly
1. Fit the blower tube (4) onto the motor housing.
2.Push the blower tube onto the housing depress the locking button and slide the tube until the lock button locates into hole.
3.To remove tube depress the lock button and slide the tube off the housing neck
Use of extension cord
WARNING. A damaged extension cord can cause electric shock or a fire. Please inspect the extension cord periodically. The tool must not be used if the cord is damaged in any way. Replace a damaged extension cord before use.
1.Use a heavy duty extension cord, suitable for outdoor use and so marked. An ordinary duty extension cord will cause loss of power and may overheat.
2.Keep the extension cord behind you, away from the area of operation.
Switching on and off
1. To switch on, move the switch (3) to the “I” position.
2. To switch off, move the switch (3) to the “0” position.
WARNING. The tool runs for approximately 5 seconds after it has been switched off. Let the motor come to a complete standstill before setting the tool down.
Operation
1.Hold the blower at an angle of approximately 45 degrees and sweep from side to side with the nozzle end about 5 to 10cm above the ground.
2.Slowly advance keeping the accumulated pile of debris in front of you.
3.If the air flow is too strong, lift the unit a little higher from the debris or blow from a greater distance from the debris.
WARNING. Flying debris can cause serious personal injury to the operator, bystanders or pets. Keep bystanders and pets at least 5m away from the area of work and always wear suitable eye and ear protection, long pants and sturdy shoes or boots whilst operating the tool.
8
