Unpacking
Due to modern mass production techniques, it is unlikely that your power tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Fitting the collection bag
1. Connect the strap (fig A) |
|
| |
onto the hook on the | B |
underside of the blower | |
vacuum housing (fig B). |
|
2.Attach the
(fig D). Push the fitting | A | |
of the collection bag |
| |
directly onto the outlet |
| |
until it “clicks” |
| |
into position (fig E). |
| |
3. To remove the collection |
| |
bag, disconnect the | D | |
attachments in the | ||
reverse order. | C | |
4. When removing the | ||
| ||
fitting on the outlet, |
| |
first depress the two |
| |
| ||
buttons on either side |
| |
| ||
of the plastic connector | E | |
(fig F), and then pull | ||
downwards on the fitting. |
| |
Finally, remove the strap | F | |
from the hook under the | ||
| ||
blow/vacuum tube. |
| |
|
|
Operation of the blower vac
Prior to using the blower vac, ensure you have read and understood this instruction manual.
•Ensure you are wearing suitable clothing and also safety equipment like safety glasses, ear protection and a mask if necessary.
•Ensure the attachments to the blower vac are correctly fitted and adjusted.
•Be aware of other people and animals in the area where you are to be operating the blower vac.
To turn the blower vac on
1. Plug the power cord into | G |
| |
an approved electrical |
|
extension cord, and turn |
|
the extension cord on. |
|
2.Ensuring the blower vac is directed in a safe direction, depress the trigger switch
(1) and the blower vac will start. (fig G).
Be sure to be holding the blower vac firmly on start up.
To turn the blower vac off
To turn the blower vac “off”, simply release the trigger switch.
Important. After you have turned the blower vac off, do not leave the product until the blower vac has been fully disconnected from the electrical supply.
To select the blow operation
1. Move the blower/vacuum selector lever (2) towards H the back of the housing
(fig H).
When the blow operation is selected, air is drawn up through the large blow/vac tube and then expelled at a much higher velocity in the
8
