Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Assembly
Wheels
Fitting the wheels
1.To fit the wheels (12) first insert the wheel bolt through the wheel.
2.Fit the wheel assembly through the holes in the bracket under the tank.
4.Completely tighten the nut from the underside of the wheel with spanner while holding the outer side nut with another spanner.
5.Repeat for the second wheel.
Wheel |
| bolt |
|
|
|
|
|
| |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| |||
Nut | |||||||||
| Bracket | ||||||||
Wheel | |||||||||
Rubber feet
Fit the rubber feet on the bracket on the front underside of the tank using the screws, washers and nuts supplied.
Oil
WARNING. The air compressor must be filled with oil before first use.
To prevent possible spillage of oil during transport, the compressor oil is supplied in a separate container. It must be added to the compressor before turning the compressor on. Failure to add the oil will cause
1.Remove the plastic oil filling plug (14) located on the top of the crank case of the compressor housing.
2.Use the oil supplied to fill the crank case until the oil level as seen in the oil level glass (16) is up to the mid point of the red circle.
3.Replace the oil filling plug (14). Ensure the plug is fully fitted and firmly in position.
9
