Air filter
1.Remove the cover (8) on the front of the generator by removing the two screws.
2.Remove the air filter.
3.Wash the air filter in solvent.
4.Lubricate the filter using engine oil (SEA #20).
5.Thoroughly squeeze the filter removing excess oil.
6.Replace air filter back into the engine.
7.Secure the cover back onto the front panel of the generator.
IMPORTANT: Never run the engine without the air filter element in place.
Tap extension fuel filter
A small fuel filter has been fitted to the inlet side of the fuel tap (4), inside the tank. This tap extension fuel filter (9) prevents any dirt in the fuel from entering the fuel system.
The procedure for removing this filter in order to replace or clean it is given below.
Note: the following procedure should be performed in a well ventilated area, with no naked flames, sparks, or cigarettes. Safety glasses should also be worn and switch (6) set to the OFF position.
1.Completely empty the tank of fuel. Ensure the fuel tap (4) is in the OFF position
2.Compress the two wire arms of the hose clamp on the outlet hose at the tap (4) and slide the clamp back from the end of the hose by approx. 25mm. Slide the fuel hose off the outlet of the tap (4).
3.Remove the 4 screws holding the fuel tank (3) to the generator assembly and lift the tank clear of the generator.
4.Loosen the lock nut locking the tap (4) on to the tank. Unscrew the tap from the tank and withdraw the tap from the tank. Be careful not to lose
the small seal on the thread of the tap.
5.Unscrew the tap extension fuel filter (9).
This filter can be cleaned in petrol to remove any
14
