Global Machinery Company LD108V instruction manual When to charge the battery

Models: LD108V

1 16
Download 16 pages 1.96 Kb
Page 8
Image 8

according to the instructions in the GMC Instruction Manual.

Do not charge the battery in a place where static electricity is generated nor let the battery touch something that is statically charged.

The battery can be stored at temperatures between

– 20° C and 40° C.

NEVER STORE OR LEAVE YOUR LITHIUM IRON BATTERY IN TEMPERATURES OVER THAT RECOMMENDED OTHERWISE FIRE MAY OCCUR.

Do NOT store the Lithium Iron battery anywhere that the temperature can easily reach higher temperatures than recommended - this includes garden type sheds, and Vehicles where the inside temperature can climb to dangerous levels in the direct sunlight and on high temperature days. THINK BEFORE LEAVING YOUR LITHIUM IRON BATTERY PACK IN STORAGE.

The battery can be charged or operated at temperatures between 0° C and 40° C.

NEVER CHARGE YOU LITHIUM IRON BATTERY BELOW OR ABOVE TEMPERATURES RECOMMENDED OTHERWISE FIRE OR SERIOUS DAMAGE TO THE BATTERY PACK MAY OCCUR.

The most suitable temperatures to charge the battery pack are between 20 - 25° C.

Always allow the battery pack to cool down after charging, do not place it in a hot environment such as a metal shed or open trailer left in the sun.

Take care where the tool is stored. Do not store in areas of corrosive fumes, or salt air or similar conditions. Try and store the tool in the packaging supplied with the tool.

Do not dispose of the battery in a fire or put the battery into a microwave oven, conventional oven, dryer, or high- pressure container.

Under these conditions, the battery may explode.

Never attempt to open the battery pack, puncture the battery or subject the battery to strong physical shock.

If the plastic housing of the battery pack breaks open or cracks, immediately discontinue its use and do not recharge it. Ensure the battery pack clip is in good condition and will not allow the pack to fall free from the tool. If the clip is damaged or for any reason is not locking the pack in place Do Not continue to use.

Stop using the battery if it exhibits abnormal heat, odour, colour, deformation, or is in an abnormal condition.

If you detect leakage or a foul odour, it is especially important to keep the battery away from fire. If battery liquid leaks onto your skin or clothes, wash well with clean water immediately. If liquid leaking from the battery gets into your eyes, do not rub your eyes. Rinse your eyes well (for at least 10 minutes) with clean water, and consult a doctor immediately. Do not use a leaking battery.

Handle batteries with care to avoid shorting the battery with conducting materials, such as nails, screws, metal watch bands, rings, bracelets, and keys. The battery may overheat and could burn you.

After the battery has reached the end of its useful life, we recommend recycling the materials at your local municipal council recycling centre. DO NOT attempt to replace the battery cells in the battery pack, repair or modify any part of the battery pack assembly

When recycling, make it nonconductive by applying insulating tape to the terminals located on the battery.

When to charge the battery

New battery packs are shipped in a low charge condition and must be fully charged before use. It takes approximately 8 hours to fully charge a new battery and 3 – 5 hours once the battery has been used in the tool a few times.

Charging of batteries should not be undertaken casually. Through the charging cycle the condition of the battery pack should be monitored and the charge cycle turned

off at completion or at the end of the recommended time.

8

Page 8
Image 8
Global Machinery Company LD108V instruction manual When to charge the battery