Global Machinery Company LS1620 instruction manual Turning on and off, Sawdust blower, LED light

table is at approximately 90º to the blade and securely tighten the table lock knob (17).

90O

3.Loosen the Phillips head screw holding the degree scale pointer and move the pointer to the 0º position. Securely tighten the screw.

Note. The degree scale is a convenient guide but should not be relied upon for precision. Always make a practice cut in scrap wood to determine if your angle settings are correct.

Turning on and off

1.To turn on the scroll saw lift the on/off switch (1).

2.To turn off the scroll saw push the on/off switch (1) down.

Sawdust blower

Your scroll saw features a sawdust blower (6) to help keep the work area clean for more accurate scroll cuts. The blower tube is factory set to direct air flow at the blade and workpiece.

LED light

The LED light will illuminate the work area for greater visibility of the cutting line.

1.To turn on the LED light press the LED light button (3) on the control panel.

Note. The LED light will not function if the saw is not in the ‘on’ position.

Adjusting the laser line

1.To adjust the laser beam first turn on the scroll saw using the on/off switch (1)

2.To adjust the laser line turn the laser line alignment knob (5) in an anti-clockwise direction to loosen it and then move it to the left or right until the laser line is in line with the blade. Turn the laser line alignment knob (5) in a clockwise direction to tighten it.

3.Turn off the scroll saw.

10