6.Align the beam with the line on the work piece.

7.Always let the blade reach full speed (approximately

2 seconds) before you begin to cut into the work piece.

8.Slowly push the saw forward using both hands, keeping the red laser light beam on the line of cut.

9.After completing your cut, release the trigger switch and allow the blade to come to a complete stop. Do not remove the saw from the work piece while the blade is moving.

Changing the blade

CAUTION. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.

1.Place saw on its side on a flat surface.

2.Rotate the saw blade by hand whilst depressing the spindle lock button (20) until the blade locks.

3.Whilst depressing the spindle lock button, turn the blade bolt anti-clockwise using the wrench provided.

4.Remove the outer blade flange and the blade bolt.

5.Raise the lower blade guard (13) using the blade guard

lever (12).

6.Remove the saw blade from the inner flange and pull it out.

7.Clean the saw blade flanges thoroughly before mounting the new saw blade. Wipe a drop of oil onto the inner and outer flange where they will touch the blade.

8.Mount the new saw blade onto the spindle and against the inner flange.

9.Replace the outer flange and tighten the blade bolt.

WARNING. The direction in which the blade rotates has to be the same as the direction of the arrow marked on the housing.

10.Ensure that the spindle lock button (20) is released.

11.Before using the saw again, check that the safety devices are in good working order.

Important. After replacing the saw blade, make sure that the saw blade runs freely by turning the blade by hand.

12.Plug the machine into a power socket and run the saw under no load to check that it runs smoothly before using it to cut any material.

13

Page 13
Image 13
Global Machinery Company LS236LS instruction manual Changing the blade, Align the beam with the line on the work piece