Unpacking
Due to modern mass production techniques, it is unlikely that your power tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool
To fit the collection bag
Prior to fitting the collection bag, the blow/vac tube must be fitted to the housing.
until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Preparation of the blower vac prior to use
The ST1800 blower vac requires some assembly prior to use for the first time.
ac b
3 2 1
This includes the fitting of the blow/vac tube to the housing, fitting the chute wheel assembly and the fitting of the collection bag.
This section also covers the fitting and removal of the shoulder strap, and adjustment of the auxilary handle.
Fitting the blow/vac tube to the housing
1.To fit the blow/vac tube into the housing, first move the upper and lower retaining clips away from the entry point of the housing.
2.Fit the tube into the entry of the housing with the large round tube section upper most in the housing.
3.Push the tube fully into the housing.
4.Move the upper retaining clip down on to the tube, and push the rubber section over the raised section of the tube. Repeat the same for the lower retaining clip.
5.The blow/vac tube is now securely in place.
Removing the blow/vac tube
1.Grasp the rubber tab on the upper and lower retaining clip and pull away from the tube. This releases the retaining clips.
2.Slide the tube outwards from the housing using a slight wobble type action.
Note. The blower vac will not operate if the blow/vac tube is not correctly fitted. This is a safety feature to prevent accidental contact with the impellor.
1.Attach the strap (1) to the hook underneath the blow/ vac tube (a).
2.Attach the
3.Connect the last strap (3) onto the hook on the underside of the blower vac housing (c).
To remove the collection bag, disconnect the attachments in the reverse order.
When removing the fitting on the outlet, first depress the two buttons as indicated, and then pull downwards on the fitting. Finally, remove the strap from the hook under the blow/vac tube.
Fitting the auxiliary handle
For full control of the blower vac during use the auxiliary handle should always be fitted and adjusted to the most suitable position for the operator.
1.To fit the handle to the housing, fully unscrew and remove the adjusting knob and bolt from the auxiliary handle.
8
