Global Machinery Company VEC156-AU instruction manual Replacing the battery pack

G

H

M

N

I J

K L

5.Carefully remove the reflector and bulb assembly (fig. G).

6.Disconnect the bulb wire from the red power wire (fig. H).

7.Unsnap the hairpin retaining wires from the reflector’s flange (fig. I).

8.Using the screwdriver, loosen the retaining screw to remove the bulb from the reflector (no need to completely remove this screw).

9.Lift out the bulb and the attached wire (fig. J).

10.Insert the replacement bulb into the reflector’s flange.

11.Put back and secure the hairpin retaining wires (fig. K).

12.Connect the white bulb power wire to the red power wire (fig. L).

13.Tighten the retaining screw on the flange (fig. M).

14.Reassemble in reverse order.

15.Operate switch to ensure proper operation of spotlight (fig. N).

Replacing the battery pack

The Sealed Lead Acid Battery has a life of several years, if recharged promptly after each use. When a fully charged battery only provides about five minutes or less of spotlight operation, it should be replaced with a new one.

To replace the battery you will need the GMC Part VEC117-AUBAT.

WARNING. DO NOT ALLOW BARE CONNECTORS TO CONTACT EACH OTHER DANGEROUS SPARKING CAN OCCUR.

NOTE. WHICH WIRES ARE ON THE BATTERY TERMINALS

CAUTION. Incorrectly connected wires will not allow the spotlight to operate. Incorrect battery polarity will damage the circuits inside the spotlight. Double check battery polarity before reassembly!

11