- Ensure the speaker is switch ON.
- Speaker’s battery capacity is low, connect the AC/DC adaptor to the speaker.
is ON.
” button on the speakers to find the transmitter frequency
Check there is not Too much water retention inside the speaker grill. Turn
O
the transmitter, move it closer.
audio source volume
evel
- Ensure the TV or audio component
- The volume of speaker is too low, adjust the volume to an appropriate level.
DISTORTED SOUND
Press the “AUTO-TUNE-
- over the speaker and let the water drain out from the speaker grill.
- Change the position of the channel selector on the transmitter. Press “AUT
TUNE” button on the speaker.
- Ensure the volume level of speaker is adjusted properly.
- The speaker is too far away from
- Audio input level of the audio signal is too low. Turn up the
- The Transmitters audio input level is too high, lower the audio source volume l
- Ideally the audio source is ON and volume level is set to at 50-75% of maximum.
SPECIFICATIONS Transmission Mode : UHF stereo
r, 4 X ‘AA’ sixe Alkaline batteries (not
line batteries (not
Frequency Response :
typical)
eparation
Chang o t expressly approved by the
party responsible for compliance could void the user’s authority to
This device mu in the package.
Carrier Frequency : 900 MHz
Operation Voltage : Transmitte
included) or DC 12V 200mA
Speaker, 6 X ‘AA’ size Alka
included) or DC 12V 1.2A adaptor
40Hz – 12KHz
Distortion : 1.0%
S/N Ratio : 65dB (
Channel S : 50dB (Typical)
Operation Distance : Up to 150 feet
Output Power : 2 x 4W (RMS)
WARNIN G: es r modifications to this unit no
operate the equipment. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that
may cause undesired operation of the device.
st be used with the AC/DC adaptor supplied
www.gracedigitalaudio.com or contact us at: info@gracedigitalaudio.com
04_2010
P.6