Graco 1466 manual Installing the Batteries, Using the Tray, Reclining Back- Four Positions, Step

Models: 1466

1 8
Download 8 pages 40.33 Kb
Page 6
Image 6
Using the Head Supports (on certain models)

Using the Head Supports (on certain models)

Installing the Batteries

To provide head support for a smaller child, your swing model may include one of the following accessories:

Two head supports:

Insert them into the pockets in the back of the cloth seat pad.

Back of cloth seat pad

Head support cushion: Use it in the seat as shown, threading the seat belt straps through the corresponding holes in the cushion.

Using the Tray

If tray does not latch, check back brace to be sure the word “REAR” is away from the seat.

Step 1.

Step 1.

With baby out of swing, open the battery compartment lid by inserting a coin (penny, nickel or dime) into the coin slot. After the lid pops open, swing it down and remove it.

Step 2.

Insert four “D” cells. CHECK that the batteries are put in correctly. Your swing will not run if the batteries are put in backwards.

Step 3.

To replace lid, put the two tabs of the lid into the two slots in the bottom of the motor housing. Swing lid up, and press it into place until you hear the latch click.

Coin Installing the BatteriesTwo head supports: slot Using the TrayReclining Back—Using the Swing

Unlatch the tray by squeezing the two latches under the tray at the same time, and lift up.

Be careful not to let the tray hit your baby when lifting or closing the tray.

Step 2.

To latch tray, push it down firmly.

Manual backgroundManual backgroundManual backgroundManual backgroundManual background Tray must be latched at all times when baby is in swing. Pull up on tray to be sure it is latched.

Reclining Back—

Four Positions

Pull adjustment wire upward and pull seat backward to recline seat. Extra pressure is required to go from the third position to full recline.

For upright position, simply lift back of seat forward.

Using the Swing

CHECK that all parts are securely fastened together before using the swing.

Step 1.

Open tray and seat belt. Place baby in the seat.

Step 2.

Fasten the seat belt. Adjust belt as needed to get a snug fit around your child.

Step 3.

Close the tray. CHECK that the tray is latched by pulling up on the tray.

Manual backgroundManual backgroundManual background Do not depend on the tray or seat belt alone to hold your baby. Always secure your baby with both the seat belt and tray when your child is in the swing.

11

 

12

 

 

Page 6
Image 6
Graco 1466 manual Installing the Batteries, Using the Tray, Reclining Back- Four Positions, Using the Swing, Step