15W034 Beacon Tower Kit Installation
15W034 Beacon Tower Kit Installation
NOTE: Kit 15W034 is for ProMix 2KS manual systems.
1.Remove the 3/4 in. (19 mm) knockout on top of the EasyKey. Feed the wires through the hole and secure the beacon (1) with jam nuts (N) on the inside and outside of the box. See FIG. 1.
1
N
TI14040a
FIG. 1: Install Beacon on EasyKey™
2.See FIG. 4. Install the din rail (7) with two screws (8). Install the header (5) on the din rail and connect the cable (4) to J5 on the EasyKey display board.
3.Connect yellow and gray wires from beacon to the power terminal. See FIG. 2.
4.Connect orange, brown, and red wires to header (5) pins 3, 4, and 5. See FIG. 6 on page 6.
5.To enable the optional audible alarm, connect sky blue wire to pin 3 on header (5). See FIG. 6 on page 6. When enabled, it will sound for all system alarms.
6.When beacon wiring is completed, insulate the end of each unused lead wire with insulation tape.
| Beacon Signals |
|
|
Flashing |
|
Signal/ |
|
Audible | Description |
|
|
Amber | A system warning is active; verify alarm. |
|
|
Red | A potlife alarm exists. System goes to |
| Standby. |
|
|
Green | Not used. |
|
|
Audible | A system warning is active; verify alarm. |
|
|
NOTE: See the ProMix 2KS operation manual for details of the specific alarms.
DC
OK
+
OUTPUT DC
Gray (Common)
AC |
|
INPUT | N |
| NC |
| NC |
Yellow (+24V)
TI14041a
FIG. 2: Power Terminal Connections
2 | 313542D |
