Service
Remove the Fluid and Side Covers (continued)
Reassembly
1.Clean all parts and inspect for wear or damage. Replace parts as needed.
2.If necessary, reinstall the felt dampener (29) and side cover (31). Torque the screws (39) to 28
3.Install new ball check seals (24).
4.Place the fluid covers (32) on the housing (1). Align the mounting holes (H) in the fluid covers with the holes in the housing. Install the screws (38) loosely, then torque oppositely and evenly to 10
5.Reinstall the pump on its mounting.
6.Reconnect the ground wire and hoses.
1 | Align | 3 | 10 |
2 | 28 | 4 | Replace seals whenever |
|
|
| cover (32) is removed. |
338
32 | H 1 |
|
|
| 24 | 4 |
| 1 |
|
|
|
| H 1 | |
4 | 24 | 39 | 2 |
|
| 31, 29 |
H 1
32
38 3 | ti1031a |
Fig. 3
309303 15