Tip and Guard on Gun

AA30 Gun with RAC Tip (257096)

1.Relieve pressure, page 2.

Operation

Setup

1.Prime sprayer. See manual 313316.

2.Slide air on/off valve on (up).

2.

Insert seat housing (27)

29

27

 

into guard (29).

 

 

3.

Insert SwitchTip (28).

 

27a 27b

4.

Insert seal (27b) over

ti8249a

28

 

seat (27a) and insert in

 

 

3. Turn air adjustment valve off at gun.

ti12855a

seat housing (27). Use black seal for water-based materials and orange for solvent and oil-based materials.

NOTICE

If air cap is not fully installed on gun, fluid pressure can force paint into air line and damage sprayer.

5.Install guard (6) over end of gun. Hand tighten firmly to ensure a good seal.

6.Replace seat (33a) and/or retighten guard nut if you notice fluid leaking from front of gun.

AA30 Gun with Flat Tip (257380)

1.Relieve pressure, page 2.

2.Insert spray tip into flat tip air

cap assembly. Insert spray tip

A

locating tab (A) into air cap

 

locating slot (B).

 

3. Install guard over end of gun.

B

 

Hand tighten firmly to ensure a

ti13263a

good seal.

 

Operation

Note: The following instructions are for guns used with Graco FinishPro Sprayers. See the sprayer instruction manual 313316. If you are using a different sprayer, see your equipment instruction manual.

ti13321a

4.Increase fluid pressure to eliminate tails.

5.

Decrease fluid pressure until

ti13279a

 

 

just before tails start to

 

 

appear.

 

 

 

ti13280a

6.

Increase air pressure with air

 

 

adjustment valve to eliminate

 

 

tails.

 

7.

Slide air on/off valve off

 

 

(down) when finished spraying

ti13281a

 

to save proper air pressure

 

setting.

Spray

1.Unlock trigger lock.

2.Be sure the arrow shaped tip (B) faces forward (spray) (257096).

3.Hold gun perpendicular and approximately 12 in. (304 mm) from surface. Move gun first, then pull gun trigger (D) to spray a test pattern.

4.Do not spray in an arc. This causes an uneven fluid coat. Spray in a path parallel to the surface, with a 50% overlap, to obtain an even fluid coat.

 

 

 

 

 

 

 

WRONG

 

 

RIGHT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

313347E

3

Page 3
Image 3
Graco 257380, 257096 important safety instructions Tip and Guard on Gun, Operation