Graco 2725, 2745 manual Using AC Adapters, Selecting Channels, Setting Up the Baby Monitor

Using AC Adapters

•The Parent Units can use either 4—1.5V “AAA”/LRØ3 batteries or standard 120 volt AC household current. The Nursery Unit uses standard 120 volt AC household current only. The included AC adapters must be used for this purpose.

•To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the unit. Then plug adapter into a standard wall outlet.

•Use ONLY the Graco adapters included with the monitor. Do not use these adapters with other equipment under any circumstances.

•If units do not work, check that AC adapters are plugged into working outlets.

•When electricity is off (from a power failure, etc.), the Nursery Unit will NOT work, since it only operates on AC current.

Selecting Channels

•Check that both Nursery Unit and Parent ’s Unit are set to the same channel.

•To change channel, slide Channel button to either A, B, X, or Y on BOTH units.

Setting Up the Baby Monitor

1.Check that Nursery Unit and Parent Units are set to the same channel.

2.Place the Nursery Unit within 10 feet (3 meters) of your baby. Plug an AC adapter into the jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet.

3.Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block sound transmission.

4.Turn on the Nursery Unit using the ON/OFF switch. The green power light should come on.

5.Install 4—1.5V “AAA”/LRØ3 batteries into the Parent Unit, or plug into a working 120 volt AC outlet using the other two AC adapters.

6.Turn on the Parent Unit using the volume control dial. The green power light should come on.

7 907-2-02