Spray Tip Selection Chart
311001G 31
RAC SwitchTips, for use with AA Series Air Cap
LTX RAC Spray Tips
Order desired tip (Part No.LTXxxx) from matrix below.
* Tips are tested in water.
❖Measured with NO airflow. Air assist will tend to reduce pattern lengths by 1 in. to 2 in.
All tips in the Spray Tip Selection Charts below can
be used with Model 249238 G40 guns equipped
with RAC air cap 288465.
Tips are sometimes packaged with other promo-
tional parts intended for the airless market. Disre-
gard extra parts.
Orifice Size in.
(mm)
* Fluid Output, fl oz/min (lpm) ❖ Maximum Pattern Width at 12 in. (305 mm)
at 2000 psi
(14.0 MPa, 140 bar)
2 to 4
(100)
4 to 6
(150)
6 to 8
(200)
8 to 10
(250)
10 to 12
(300)
12 to 14
(350)
14 to 16
(400)
16 to 18
(450)
18 to 20
(500)
0.009 (0.229) 11.2 (0.33) 209 309
0.011 (0.279) 16.6 (0.49) 211 311 411 511
0.013 (0.330) 23.3 (0.69) 213 313 413 513
0.015 (0.381) 30.8 (0.91) 215 315 415 515 615
0.017 (0.432) 39.5 (1.17) 217 317 417 517 617
0.019 (0.483) 49.7 (1.47) 219 319 419 519 619
0.021 (0.533) 60.5 (1.79) 321 421 521 621 721
0.023 (0.584) 72.7 (2.15) 423 523 623
0.025 (0.635) 85.9 (2.54) 525 625
0.027 (0.686) 100.0 (2.96) 527 627 827
0.029 (0.737) 115.6 (3.42) 629
0.031 (0.787) 131.8 (3.90) 531 631
0.033 (0.838) 149.4 (4.42)
0.035 (0.889) 535 635
Fluid output (Q) at other pressures (P) can be calculated by this formula: Q = (0.041) (QT)
where QT = fluid output (fl oz/min) from the above table for the selected orifice size.
P