Installation
Installation
Wall Packages
1. Install bracket to the side of the existing air motor bracket. Secure using bolts (6), washers (9), and nuts (10).
2. Slip bracket holes over bolt heads and slide into place.
3. Tighten bolts.
4. Grease adapter
5. Install pump hose fitting (2b) into the lower and tighten the jam nut (2c)
6. Open clamp (4) around hopper outlet.
7. Use 7/8” hex on outlet hose fitting (2a) to rotate the hose in the hopper (1) for optimal fit in the bracket (8).
8. Tighten the adjustable screw on the clamp (4) and close latch.
NOTE: The adjustable screw should be tight enough that the latch on the clamp has firm resistance when closing.
Stand Packages
1. Loosen the two stand bolts on either side of the existing air motor bracket.
NOTE: Nuts (10), washers (9), and bolts (6) are used with wall packages only.
2. Slip bracket holes over bolt heads and slide into place.
3. Tighten bolts.
4. Grease adapter
5. Install pump hose fitting (2b) into the lower and tighten the jam nut (2c).
6. Open clamp (4) around hopper outlet.
7. Use 7/8” hex on outlet hose fitting (2a) to rotate the hose in the hopper (1) for optimal fit in the bracket (8).
8. Tighten the adjustable screw on the clamp (4) and close latch.
NOTE: The adjustable screw should be tight enough that the latch on the clamp has firm resistance when closing.
4 | 334011B |
