37
1. For ease of installation, extend
LATCHto its maximum length
and remove from storage bars.
2. Position base in vehicle seat as
shown.
3. Make sure LATCHis through
vehicle/LATCH belt path normally
used for vehicle seat belt. .
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower
anchors. Pull firmly on Connectorsto
be sure they are attached .
5. TightenLATCH by pushing down
hard on base and pulling the
adjustment belt .
6. NEVER put two LATCHconnectors
on one vehicle LATCHanchor unless
specifically allowed by the vehicle
manufacturer .
7. Test infant restraint for secure
installation as described in infant
restraint
„Final Safety Check‰ page 40
.
8. Check that theLATCH stays tight
and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Graco at 1-800-345-4109.