Graco 3625 manual Assembling Highchair, Step

Assembling

the Highchair

Step 1.

Hold front tube with ends up. Place a foot (smooth side up) at one curved corner of tube. Insert a screw through tube and into foot, then tighten. Repeat with other corner and both feet of rear tube.

Step 2.

Lay seat face down on the floor as shown. Insert support tube through both collars on bottom of seat.

Step 3.

Mount a slider onto each end of the support tube. Slider loops should be facing UP, as shown. Push end of slider all the way into collar.

Step 4.

Insert both ends of upper tube into slider loops and pull all the way through as shown.

Still holding ends of tube, locate pegs. Push pegs through the channel until they pass the snap. Slide pegs into first notch of height-adjustment track.

Pegs

Step 5.	Both “U”
Hold rear tube as shown.	curves up
Slide plastic brackets onto
upper tube.
Plastic bracket

Step 6.

Slide front tube onto upper tube as far as it will go, until the holes in the tubes line up.

Collars

Support tube

“U” curve

down

Step 7.

Pull rear tube up until holes in plastic bracket line up with holes in the tubes.

CHECK that holes in upper tube, front tube AND plastic brackets all line up with each other.

Insert a T-nut into one plastic bracket hole. It must pass through both tubes, as shown enlarged below. Insert a screw into other side of plastic bracket and screw it into T-nut.

CHECK that tubes are securely connected by trying to pull them apart.

Repeat for other plastic bracket.

First notch of

height adjustment track

226-10-99 IS3556 5 6