To Assemble Highchair
Step 1.
Hold front tube with ends up. Place a foot (smooth side up) at one curved corner of tube. Insert a screw through tube and into foot, then tighten. Repeat with other corner, then with both feet of rear tube.
Step 2. | Collars |
Lay seat face down on the floor as shown. Insert support tube through both collars on bottom of seat.
Support tube
Step 3.
Insert recline bar into one recline bracket (brackets have “L” and “R” on inside), with curved side of bar toward the bracket. Then attach bar and both recline brackets onto each end of the support tube as shown.
Step 5.
Hold rear tube as shown. Slide plastic brackets onto upper tube.
Plastic bracket
Step 6.
Slide front tube onto upper tube as far as it will go, until the holes in the tubes line up.
“U” curve
down
Both “U” curves up
5
T
S
St fro at ba re w th fro
S
Pl
S
Pu th se ho le
Insert at end | “L” bracket |
|
Curved side of | “R” bracket |
recline bar |
|
Step 4.
Insert both ends of upper“U” curve up tube through holes in recline
brackets and pull all the way through as shown. 
Still holding ends of tube, locate pegs. Push pegs through the channel until
they pass the snap. Slide pegs into first notch of
Pegs
First notch of
5 |
Step 7.
Pull rear tube up until holes in plastic brackets line up with holes in the tubes. 
CHECK that holes in upper tube, front tube AND plastic brackets all line up with each other.
Step 8.
Insert a
Insert a screw into other side of plastic bracket and screw it into the
CHECK that tubes are securely connected by trying to pull them apart.
Repeat for other plastic bracket.
Set highchair upright.
6
yo Av
S
Pu th pa
S
At po se si on
S
Pu bo tw se
Fr pu an
If ha st
