SEAT PAD WITH POCKET:

Your highchair will have either a seat belt or a 5-point harness. Follow the proper instructions below.

Step 1.

SEAT BELT MODELS:

Position seat pad over highchair. Pull the seat belt through the hole in the middle of the seat pad.

5-POINT HARNESS MODELS:

Straps must first be removed from seat before pad can be attached. Behind the seat back, locate four small plastic retainers on the shoulder straps. Push them through the slots in seat to the front. Set straps aside.

Position seat pad over highchair. Push each plastic retainer through proper hole in seat pad and back into slot it was removed from, as shown. (The strap length adjust- ment buckles will be near the shoulders.) Avoid twisting straps.

Two levels of shoulder holes are provided. Choose the level that is at or slightly above your child’s shoulders.

Pull crotch strap and buckle through center opening in seat pad.

Step 2.

Attach seat pad by sliding pocket over the back of the seat as shown.

NOTE: On certain models with a cloth pad, pad is reversible. Turn pocket inside out to reverse.

To Use Restraint

SEAT BELT MODELS:

Place crotch strap between child’s legs and snap both side buckles to the center buckle. Adjust belt as needed to get a snug fit around your child.

Push in on front of buckle to release.

7

HARNESS MODELS:

Place the crotch strap between your child’s legs and insert the harness buckles into the center buckle housing. Adjust shoulder straps as needed (pull adjust- ment buckles down to loosen harness, push them up to tighten harness) to get a snug fit around your child. Check that belt is tightly threaded through retainers behind seat.

Slack Tighten

length

 

adjustment

Loosen

buckle

 

To release, squeeze buckle at right and left sides of center housing.

Prevent serious injury or death from falls or sliding out. Always secure your child in the restraint. Do not depend on the tray alone to hold your child.

The position of the shoulder straps can be adjusted for the size of your child. Locate the small retainers behind the seat back, push them through to the front and move them to the higher or lower position as needed.

If it becomes necessary to remove the seat belt, follow these instructions:

SEAT BELT MODELS:

Step 1.

Unthread both ends of seat belt through the buckles as shown.

Step 2.

Pull one end of the seat belt through the belt retainer as shown.

Step 3.

To rethread buckle, reverse the above steps. CHECK that the belt is threaded correctly by pulling on the seat belt. The belt should not slip through the buckle.

HARNESS MODELS:

Remove seat pad. Follow directions given under “To Attach Seat Pad” to remove harness straps from seat.

8

Page 4
Image 4
Graco 3835 manual To Use Restraint, Seat PAD with Pocket, Seat Belt Models, Point Harness Models