To Assemble the Playtray (on certain models)
Do not install the playtray while your baby is in the activity center.
CHECK that you have all the parts listed at right before assembling your playtray.
|
|
| Music key (3) |
Steering wheel | Teether and | Phone | Bar, two beads, |
and cap | stalk (style | and cord | one ring |
| may vary) |
| Stickers |
|
|
|
Step 1.
Assemble the toys on the tray as shown.
Push and twist the ring and two beads onto the toy bar.
Snap the toy bar into the holes in the playtray; slight curve in toy bar must curve away from steering wheel. Be sure both ends of the toy bar are firmly snapped into the playtray.
Once the toy bar is inserted into the playtray, you will not be able to remove it.
Push end of phone cord through small hole in tray, then tie a knot under the tray.
Pull on phone cord to make sure cord is secure.
Push wheel cap onto steering wheel, then push assembly into large hole in tray. Check that all four tabs go into hole in tray.
Insert teether stalk into the small square hole in the tray.
Remove and DISCARD pull tab from printed circuit board. Then snap music keys in place over the circuit board.
Place three stickers on front of tray as shown. Rub over stickers with hand or clean cloth to assure adhesion.
Step 2.
Line up front of playtray with front edge of activity center tray as shown.
Step 3.
Push playtray down so both side tabs snap under the activity center tray.
Step 4.
CHECK that playtray is secure on activity center by pulling up on playtray.
Do not lift this product by the playtray.
To Remove the Playtray
To remove tray, pull the two side tabs outward, and lift up playtray.
9 | 10 | |
|
|
|
