Graco 6500 Series Parts List, To Unpack Stroller, To Assemble Front Wheels, To Assemble Rear Axle

PARTS LIST

CHECK that you have all the parts listed below

BEFORE assembling your stroller.

If any parts are missing,

call Customer Service at 1-800-345-4109

or visit our Internet website, www.gracobaby.com.

THIS PRODUCT REQUIRES ADULT ASSEMBLY.

No tools required for assembly.

	Left
	Right
Frame	Arm bar (2)
	(on certain models)

Front wheel		Rear wheel (2)			Rear axle
assembly (2)					mount (2)
		Cap
				Retainer
	(2, 1 extra)		(2, 1 extra)

Rear axle

To Unpack Stroller

To prevent serious injury or death from choking, remove and IMMEDIATELY discard the plastic covers on the front leg pins.

Plastic cover

Zip tie

Step 1.

Flatten stroller carton to protect floor.

	Storage
Step 2.	latch
Release storage latch. Flattened
	carton

Step 3.	Locking
	latch

Open stroller on carton until locking latches on both sides are locked.

To Assemble Front Wheels

Step 1.

Line up pin on bottom of front
leg with the wheel assembly as
shown. Plastic snap inside
wheel mount must be away	Plastic
from pin.
	snap

Step 2.

Push wheel assembly onto pin until it snaps in place.

Step 3.

Repeat for other wheel.

Pull firmly on each wheel assembly to be sure the wheel assemblies are securely attached.

To Assemble Rear Axle

Step 1.	Brakes face
Turn stroller over and position	rear of stroller
rear axle mounts on rear legs
as shown. Brake levers must
face rear of stroller. Push axle
mounts on until plastic tabs
snap into the slots on the legs.

Step 2.

CHECK that axle mounts are securely attached by pulling firmly on each axle mount.

To prevent serious injury or death from choking, remove and IMMEDIATELY discard the plastic covers on the ends of the rear axle.

Step 3.

Put the axle through both axle mounts and the center support as shown.

762-3-00 5 6