Graco 7500 manual To Assemble Rear Wheels, To Unfold Stroller To Assemble Front Wheels

Step 3.

Push both brackets all the way on until metal buttons snap into bracket holes on inside of legs.

Pull firmly on each bracket to be sure buttons are snapped into bracket holes.

To Assemble Rear Wheels

Place one rear wheel, red retainer, and white cap on one end of rear axle in order as shown below. Push red retainer onto axle BEFORE attaching white cap. Repeat on other

To Install Storage Basket (on certain models)

Step 1.

Snap basket support wire onto rear legs as shown.

Step 2.

Fasten the two straps around front legs, above the side braces, as shown.

Straps

side.

Spokes toward inside

Rear axle

Snap red retainer into axle groove. Then snap cap over red retainer as shown.

Be sure cap is snapped securely over red retainer.

Wheel

Cap (white) Attach AFTER retainer is on axle

Retainer (red) Wide end toward wheel

Side brace

Snaps

Step 3.

Fasten the bottom row of snaps around the rear axle.

Step 4.

Fasten the top row of snaps around the basket support wire.

To Unfold Stroller

To Assemble Front Wheels

Step 1.

Step 1.

Snap swivel lock button onto wheel mount as shown. This must be done BEFORE pin is inserted (next step).

Step 2.

Insert pin through hole in wheel mount. Then push round end of a front wheel assembly up onto pin as shown until it snaps into place.

Check wheel attachment by pulling down on the front wheel assembly.

Insert pin

Round end

Unfold footrest from under armrest.

Step 2.

Release storage latch.

OR

Step 3.

Unfold as shown.

Step 3.

Push

Repeat above steps for thewheels up other side.

7

Be certain the stroller is fully erected and latched before allowing your child near the stroller.

8