Graco EZ manual Installing Car Seat In Vehicle

❃InstallingCarSeatInVehicle

Follow instruction manual provided with car seat for installation in vehicle; use the EZ LATCH™ in place of the vehicle seat belt.

1For ease of installation, extend EZ LATCH™ to its maximum length.

2Position car seat, rear-facing or forward-facing, correctly for your child

(Fig. a or Fig. b).

IMPORTANT: Release Buttons must face up and Adjuster must face outward so belt can be adjusted without interference (Fig. a).

3Thread EZ LATCH™ through car seat belt path normally used for vehicle seat belt, as shown in car seat manual.

Belt must lay flat and not be twisted.

4Hook Connectors to vehicle lower anchors. Pull firmly on Connectors to be sure they are attached (Fig. c).

5Tighten EZ LATCH™ by pushing down hard on car seat and pulling the adjustment belt (Fig. d).

6Test car seat for secure installation as described in car seat instruction manual by pulling front-to-back and left-to-right.

7Check that the EZ LATCH™ stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.

8For forward-facing car seats only, attach the top tether strap and tighten top tether strap.

Forward-facing car seats SHOULD use a top tether strap in addition to EZ LATCH™.

If you do not have a top tether strap, call

1-888-224-6549 with your model number and date of manufacture to see if a top tether strap is available for your model.

Each trip check that car seat is securely installed; tighten if necessary.

5