Locking Clip | Graco ISPC001BA specs

VEHICLE SEAT BELTS (continued)

❃LockingClip

WARNING

Avoid serious injury or death:

•Failure to use locking clip where required will result in car seat not being securely held in place.

•Remove locking clip from seat belts when not being used with car seat.

•DO NOT use locking clip as a vehicle seat belt shortener.

You MUST use locking clip provided with car seat with a vehicle seat belt that slides freely through the latch plate or the lap belt cannot be tightly secured.

1Install car seat and tighten vehicle seat belt.

2Hold seat belts together at latch plate (fig. a) then unbuckle.

3Slide locking clip on seat belts approximately 1/2 inch (1 cm) away from latch plate.

4Re-buckle seat belt.

5Test installation to see if car seat is secure.

If not secure, additional belt tightening may be required:

•Unbuckle vehicle seat belt.

•Hold belts together and remove locking clip.

•Shorten length of lap belt portion slightly by pulling belt through latch plate.

•Re-attach locking clip.

•Buckle vehicle seat belt.

Press car seat further down into vehicle

seat cushion to help buckle vehicle seat belt.

Test installation to see if car seat is secure. If not secure, repeat above step until secure.

1/2 inch (1 cm) (fig. a)

31

Image 33

Graco ISPC001BA manual Locking Clip

Contents

Avoid injury or death Table of Contents Important Information Safety First Check ListRegistration Information Latch Do not use rear-facing child Replaced. do not use it again! a Certification Basic InformationCar Seat Useful Life Vehicle Seat Protection Latch System for Vehicles What is LATCH?Vehicle Top Tether Anchor Points Lower Anchor Vehicle Seat Crease Vehicle Lower Anchor Points Latch System Preterm or Low Birth Weight Infants Height & Weight LimitsOutgrowing Car Seat Rear-facing 5 to 30 lbs .6 kg REAR-FACINGINSTALLATION with Latch Fig. d Tether Openings Towels FORWARD-FACING Installation with Latch Tether Openings Pull to tighten FORWARD-FACING Installation with Latch REAR-FACING Installation with Vehicle Seat Belts Storage Bar Openings Towels Tether FORWARD-FACING Installation with Vehicle Seat Belts Fig. e Stand Check harness system Placing Child in CAR SeatPoint Models Only Overhead Shield Models Only Placing Child in CAR Seat Harness Straps fig. a Harness TieOverhead Shield Models Upright Lift Pull BeltRecline Changing Harness Strap Slots Point Models fig. e For Infants or Small ToddlersFor Toddlers Loop Splitter Plate Top Loop Bottom Latch belt. fig Latch Belt Routing Forward-facing Rear-facing Fig. l Removing Latch from Vehicle Anchor Points Fig. p Latch storage Vehicle Seat Belts Belts Forward of Seat Crease Vehicle Seat Belts Lap Belts Manually Adjustable Lap Belts With RetractorFlip Passive Restraint Lap or Shoulder Belt Mounted on Door Passive Restraint Lap Belt with Motorized Shoulder Belt Combination Lap/Shoulder Belt with Sliding Latch Plate Combination Lap/Shoulder Belt with Locking Latch PlatePull Locking Clip Tether Storage Additional InformationFor storage of tether hook Tether Hook Back of Car Seat Available on some models Cup HolderRemoving Cup Holder Tab Care & Cleaning Removing Seat PadRemoving Overhead Shield Pad Second Hand Car Seat Aircraft Use How to Order Parts List Both Numbers Required Ship to Call US First Manual de instrucciones Tabla DE Contenido UtilizaciónInformación especial Información Importante Información de registroLista de control de seguridad Advertencia Prevenga lesiones graves o la muerte Orientación trasera debe nivelarse Información Básica Advertencia ¿QUÉ ES EL LATCH? Sistema Latch para vehículosAnclaje El sistema Latch Sistema Latch De 20 a 40 libras de 9,0 a 18,1 kg Límites DE Altura Y Peso Instalación Orientada Hacia Atrás CON Latch Anclaje Aperturas Toallas Instalación Orientada Hacia Delante CON Latch Anclaje Aperturas Jale para Apretar Advertencia Anclaje Barra de Almacenaje Aperturas Advertencia Aperturas Jale para Apretar Anclaje Barra de Compruebe el sistema del arnés Colocar AL Niño EN EL Asiento DE SeguridadModelos de 5 puntos solamente Modelos con barra protectora solamente Modelos Operaciones Y Ajustes Levante Jale El cinturónVertical Reclinada Modelos de 5 puntos fig. e Para bebés o niños pequeños Para niños más grandesModelos con barra protectora fig. f Fig. f Soporte Fig. e Bucle Placa de unión Giratorio debajo De la almohadilla Del asiento Usar el sistema Latch orientado hacia atrás. o Retirar el Latch de los puntos de anclaje del vehículo Fig. p Barra de Almacenaje Almacenaje Latch Cinturones DE Seguridad DEL Vehículo Pliegue del Asiento Cinturones ubicados delante del pliegue del asiento Cinturones de regazo ajustables manualmente Cinturones de regazo con retractorDéle la vuelta No SE Debe usar con ningún asiento Fig. a Déle la vuelta Jale Pulgada 1 cm Clip de cierre Información Adicional Almacenaje del anclajeGancho del anclaje Parte trasera del asiento Disponible en algunos modelos PortabebidasPara quitar el portabebidas Pestaña Cuidado y limpieza Retirar la almohadillaRetirar la almohadilla de la barra protectora Asiento para autos de segunda mano Uso en aeronavesLas almohadillas del asiento y de la barra protectora Armazón y apoyavasos de la barra protectora Cómo efectuar pedidos Lista DE Piezas Se requieren ambos números Envíe a Llámenos Primero