Graco ISPC054BA manual REAR-FACINGINSTALLATION with Latch

REAR-FACINGINSTALLATION WITH LATCH

1LATCH belt must be routed through

opening in child restraint for rear-facingmode. (see page 23, fig. k).

Belt must lay flat and not be twisted.

2Adjust child restraint to recline position (see pages 18 and 19, fig. b) and place rear-facingon vehicle seat equipped with LATCH anchors.

3For ease of installation, extend LATCH belt to its maximum length.

4Hook connectors to vehicle lower anchors (fig. a). Pull connectors to be sure they are securely attached to the anchor points. (fig. b).

5Press down firmly in center of child restraint while pulling LATCH adjustment belt. (fig. c).

6

7

Pull front to back and left to right to check for secure installation (fig. d).

Check that the lower anchorage belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service (see back cover).

Check level indicator on child restraint.

Vehicle must be on level ground and child in child restraint when checking level indicator.

Ball MUST be entirely in green zone (fig. e). If necessary, place rolled towels under child restraint, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator.

DO NOT use tether rear-facing. Tether must be stored (see “Tether Storage” page 32).

Periodically check that child restraint is securely installed and properly leveled; adjust if necessary.

8