Graco ISPC116BA instruction manual Combination Lap/Shoulder Belt with Sliding Latch Plate, Pull

VEHICLE SEAT BELTS (continued)

❃Combination Lap/Shoulder Belt with Sliding Latch Plate

Pull on latch plate (fig. b). If belt slides freely through latch plate, a locking clip MUST be used (see Locking Clip section).

Some combination lap/shoulder belts with sliding latch plates may be converted into an “automatic locking mode” that will allow use without a locking clip. See vehicle owner’s manual and label on vehicle belts for instructions.

❃Combination Lap/Shoulder Belt with Locking Latch Plate

The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip the latch plate over (fig. c) and re-buckle. Test installation again to see if this works. If not, move car seat to another seating position.

Pull

(fig. b)

Flip

(fig. c)

26