Pull front to back and left to right to check for
secure installation (fig. d). Vehiclelap belt
MUST stay tight.
If not secure, see “VehicleSeat Belts” page 26.
Check level indicator on child restraint.
Vehiclemust be on level ground and child in
child restraint when checking level indicator.
Ball MUST be entirely in green zone (fig. e).
If necessary,place rolled towels under child
restraint, at vehicle seat crease, until entire ball
is in green zone. Then re-check level indicator.
DO NOT use tether rear-facing. Tethermust
be stored (see “TetherStorage” page 32).
Periodically check that child restraint is
securely installed and properly leveled;
adjust if necessary.
Store LATCHbelt by attaching to connectors
through forward-facing openings
(see page 25, fig. r).
•Attach connectors to storage bar on each
side (fig. a).
•Adjust LATCHbelt to remove excess
slack by pulling adjustment belt.
Adjust car seat to recline position
(see fig. b and pages 18 and 19, fig. b).
Place rear-facing on vehicle seat.
Thread vehicle seat belt through openings and
buckle belt.
Press down firmly in center of child restraint to
compress vehicle seat cushion while tightening
vehicle seat belt (fig. c).
REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS
1
3
4
5
2

12

LATCH belt MUST be stored when

using vehicle seat belt to install

child restraint.

WARNING
6