•Combination Lap/Shoulder Belt with Sliding Latch Plate
Locking clip
This belt has a latch plate that slides freely along the belt.
This belt MUST be converted to prevent movement of the lap portion of the belt. You must use a locking clip (provided with the infant restraint) when using the infant restraint without the base unless your vehicle's seat belt can be converted in another way as described in your vehicle owner's manual.
To Install Locking Clip: (DO NOT use with base)
1.Tighten the buckled belt by pushing down hard on the infant restraint and pulling hard on the shoulder belt.
2.While pushing down on infant restraint, pinch the two straps together behind the buckle tongue. Unbuckle the belt
without allowing it to slip.
1/2 inch (1 cm)
➊
➋
3.Connect lap and shoulder belts with locking clip as shown ➊ and ➋.
4.Rebuckle belt. Check that lap belt does not move by pulling and pushing hard on infant restraint. If belt loosens or lengthens, repeat procedure.
Locking clip goes here, 
1/2 inch (1 cm) from the buckle
31
