8.5 With OR Without Built-in Harness

8.6 To Install Locking Clip

‡Combination LapShoulder Belt with Locking Latch Plate

Once it is buckled, this type of belt has a latchplate that will not allow the lap portion of the belt to loosen. Belt is tightened by pulling hard on the shoulder portion of the vehicle belt while pushing down hard on the child restraint.

‡Combination LapShoulder Belt with Sliding Latch Plate This belt has a latchplate that slides freely along the belt.

‡This belt MUST be converted to prevent movement of the lap portion of the belt. You must use the locking clip provided with the child restraint, unless your vehicle's seat belt can be converted in another way as described in your vehicle owner's manual.

When using booster seat WITHOUT the built-in harness, locking clip is NOT

to be used.

Locking clip

22

1. Tighten the buckled belt by pushing down hard on the child restraint and pulling hard on the

shoulder belt.

2. While pushing down on seat, pinch the two straps together behind the buckle tongue. Unbuckle

the belt without allowing it to slip.

3. Attach locking clip to lap and shoulder belts as shown ™.

4. Re buckle belt. Check that lap belt does not move

by pulling hard. If belt loosens or lengthens, repeat procedure.

Remove locking clip when not using child restraint. Store

 

 

 

under it’s tab on the rear of seat.

 

 

 

Test installation to see if child restraint is secure.

 

 

 

If not secure, additional belt tightening may be required:

 

 

 

 

™

 

‡ Unbuckle vehicle seat belt.

 

 

12” (1.25 cm)

‡ Hold belts together and remove locking clip.

‡ Shorten length of lap belt portion slightly by pulling belt through latch plate. Re-attach locking clip.

‡Buckle vehicle seat belt. Press child restraint further down into vehicle seat cushion to help buckle vehicle seat belt. Test installation to see if child restraint is secure. If not secure,

repeat above steps until secure.

23

 

Page 12
Image 12
Graco PD169096A owner manual With or Without Built-in Harness To Install Locking Clip, Repeat above steps until secure