Graco Inc 4043, 308532S important safety instructions Shutdown, Flushing, and Storage, Maintenance

Shutdown, Flushing, and Storage

CAUTION

Do not expose pressure washer to freezing tem- peratures or allow water to freeze in pressure washer components. If water freezes in the pres- sure washer, thaw it in a warm room before you try to start it. Do not pour hot water on or into the pump; it may crack the ceramic plungers!

DDo not store unit outside where it will be exposed to rain, dirt or adverse weather conditions.

DBefore you store the pressure washer overnight or transport it, disconnect the water supply, and turn off the fuel supply valve.

DAfter each use, wipe all surfaces of the pressure washer with a clean, damp cloth.

Engine:

1.Run engine until gas is gone or stabilize the fuel and run it through the fuel system and carburetor.

2.Drain water out of pressure washer hose.

3.Turn fuel system to OFF position.

Pump:

4.Attach one end of a 4 or 5--foot section of hose to pump inlet and other end in an antifreeze solution approximately 1--foot off the ground.

NOTE: An anti--freeze flush kit, P/N 802327, is available to make flushing easier.

5.Pull pull--cord on engine until antifreeze comes out of pump outlet.

Storage Location:

6.Store pressure washer in garage, basement or other area where it is protected from freezing temperatures.

DAfter each use, wipe all surfaces of the pressure washer with a clean, damp cloth.

DPerform the appropriate maintenance. See Mainte- nance Chart.

Maintenance

Observing regular maintenance intervals helps ensure that you get maximum performance and life from the pressure washer.

There is a break--in period for the engine and pump. After changing the oil in these components following their respective break--in periods, the interval between required changes is longer.

If the unit is operating in dusty conditions, these maintenance checks should be made more often.

WARNING

To reduce risk of serious bodily injury, including fluid injection, splashing in eyes or on skin or injury from moving parts, always follow Pressure Relief Procedure on page 6 before proceeding.

Interval	What to do
Daily	Clean water inlet screen and
	filter. Check engine and pump oil
	levels. Fill as necessary. Check
	gasoline level. Fill as necessary.
After first 5	Change engine break--in oil.
hours of	Drain oil when warm. Use SAE
operation	30 or 10W--30 detergent oil.
Each 25 hours	Clean and remove air cleaner
of operation	foam. Wash with water and
	detergent. Dry thoroughly. Rub
	with oil and squeeze to distribute
	oil.
After first 50	Change pump break--in oil. Use
hours of	SAE 20 or 30 non--detergent oil
operation	or genuine CATr pump oil.
Each 100 hours	Clean or replace paper air
of operation	cleaner cartridge. Tap gently to
or 3 months	remove dirt. Change engine oil.
	Use SAE 30 or 10W--30
	detergent oil.
Each 500 hours	Change pump oil. Use SAE 20
of operation	or 30 non--detergent oil or
or 6 months	genuine CATr pump oil.

308532 9