6 309662
Component Description

Compressor Requirements

NOTE: This sprayer requires an external air compres-
sor.
C
A
UTION
Install an air filter on external air compressor to
reduce contamination to spray system.
Air compressor range: 10 scfm to 35 scfm, 30 to 140
psi (0.2--0.97MP a, 2 to 9.7 bar)
Material AirRequirements* Minimum
Compressor
Size*
Elastomerics
(textured)
30 scfm at 90 psi
(0.84 m3/minat
0.63 MPa, 6.3 bar)
15 HP
Simulated
Accoustical
20 scfm at 60 psi
(0.56 m3/minat
0.42 MPa, 4.2 bar)
5.5 HP
SplatterCoat
and
Knockdown
15 scfm at 40 psi
(0.42 m3/minat
0.28 MPa, 2.8 bar)
8HP
Orange Peel 20 scfm at 60 psi
(0.56 m3/minat
0.42 MPa, 4.2 bar)
8HP
* Material, temperature and volume affect cfm needed
to properly atomize material.
Maintenance
C
A
UTION
DFor detailed engine maintenance and specifica-
tions, refer to separate HONDA engine manual.
DClose black fuel shutoff lever whenever you are
transporting sprayer to prevent fuel from flooding
engine.
DKeep sprayer upright and level when operating it
and when transporting it. This prevents crankcase
oil from leaking into combustion chamber, which
makes startup very difficult.
Daily: Check engine oil level and fill as needed.
Daily: Check andf ill gas tank.
Daily: Check sprayer air filter, clean and replace
element as needed.
Afterfirst 20 hours of operation and each 100
hours thereafter:Change oil.
Weekly: Remove engine air filter cover and clean
element. In very dusty environments, check filter daily.
Replace element as needed. Replacement elements
can be purchased from your local HONDA dealer.
Sparkplug: Use only a (NGK) BP6ES or BPR6ES
plug. Gap plugto 0.025 to 0.030 in. (0.7 to 0.8 mm).
Always use a spark plug wrench.
6 months:Clean Ai r Flow Sensor as follows:
1. Fig. 3. Loosen adapter (A). Pull down quick re-
lease (C) and swing out flow sensor regulator.
Disconnect connector (B).
2. Removeinlet fitting (D), retainer ring (E), piston (F)
and spring (G) from flow sensor regulator (H).
C
A
UTION
Do not scratch or nick piston (F) or inside of flow
sensor regulator (H).
3. Clean all parts (D, E, F,G). Clean inside of (H)
with a pipe cleaner.
4. Assemble all parts and install flow sensor regula-
tor.
Flow
SensorRegulator
A
C
ti4366a
Flow
Sensor Regulator

B

D E FG H

Fig. 3