Graco Inc 02748, 308-341, 949-239



Notes

Contents

Main Table of Contents Symbols Warning Symbol Caution Symbol WARNING PRESSURIZED EQUIPMENT HAZARD FIRE AND EXPLOSION HAZARD TOXIC FLUID HAZARD Selection Chart Includes: Selecting a Needle/Nozzle/Air Cap Kit Selection Problems and Solutions Air Flow and Atomizing Pressure Air Flow Atomizing Pressure Versus Activator Inlet Pressure Atomizing Air Pressure Installation Fluid Compatibility of Accessories Ventilate the Spray Booth Installation Air Line Accessories Fluid Line Accessories and Shutdown Pressure Relief Procedure Removing and Installing the Fluid Nozzle 1. Connect the air line. 4. Connect the activator tube. 5. Position the Air Cap for a vertical or horizontal spray pattern. See Fig. 11. 6. Adjust the spray pattern. 6. Adjust the spray pattern. (continued) , 7. Adjust the activator fluid flow. 8. Shut down the system 9. Place the gun nozzle in soapy water over-night Ratio Check 1. Check the ratio of the adhesive. 2. Check the ratio of the activator. 3. Adjust the ratio as needed. 1. General system maintenance. 2. Flush the gun. 3. Clean the gun. Page 3. Clean the gun. (continued) 4. Lubricate the following gun parts daily, 308-34117 Troubleshooting PROBLEM CAUSE SOLUTION Items Needed for Service Disassemble Page Assemble Page Page Page Parts Drawing Parts List Nozzles, and Air Caps. which may be purchased separately Repair Kit 949285 Technical Data Manual Activator Only Adhesive and Activator Page The Graco Warranty and Disclaimers MINNEAPOLIS, MN GRACO INC. P.O. BOX 1441 All