Graham Field 1147 specifications QUICK-START Guide, Taking a Measurement, Troubleshooting

SIZE:72*97MM

		SAFETY PRECAUTIONS					QUICK-START GUIDE		OVERVIEW
		Babies, young children, or individuals who cannot express					Avoid smoking, eating or exercising for 30 minutes before		Monitor
		their consent are not suitable for blood pressure					taking a measurement.
		measurement.					Do not move or talk during measurement.
									Date & Time
		Individuals with serious arteriosclerosis are not suitable					Measurement can be taken on either arm; however, if
											Systolic
Advanced Wrist Blood Pressure Monitor		for blood pressure measurement.							User 1~ 4
							possible, always take measurements on the left arm.
									Memory Average
Model 1147		Blood pressure readings may fluctuate during pregnancy.							Memory
		Pregnant women should consult their doctor before taking					1. Sit upright in a chair with your				Diastolic
Instruction Manual
		measurement.					feet on the floor.		Indicator
									Low Battery
		If there are unusual values, please consult your doctor					2. Remove tight-fitting or thick		Pulse Symbol		Power
		before taking medical action.					clothing from the lower arm.		Memory Recall		(Start)
		Handling batteries properly:					3. Pull on the end of the cuff until it wraps		(Up)		WHO Light
							securely around your wrist. Place your				Indicator
		- As soon as old batteries wear out, replace them with new							Average Values	Page Select
							arm on a table so that the cuff will be				Memory No.
		batteries.							(Set)	(Down)
Kpa							at the same level as your heart.				(1-99 readings)
		- Do not use old and new batteries together.
							4. Press the “ ” button.The cuff will automatically inflate and
		- Align the polarities of batteries correctly.							Features
							the measurement will start.
		- When the unit will not be used for more than 3 months,							• One Touch Operation
		remove the batteries. Otherwise, batteries may leak and					5. When the measurement is		• Irregular Heartbeat Detector
		cause damage to the unit.					complete, the cuff will		• Blood Pressure Mode and Clock Mode
							automatically deflate and your		• 4 User / 396 Total Memory
							systolic and diastolic pressure		• 4 Alarm Clock Settings
							values and pulse rate will display.		• 5 Mode Averaging Function – Hour, Day, Week, Month,
Read these instructions before using your Blood									and Overall
									• WHO Blood Pressure Indicator with 6-Color LED
Pressure Monitor. Save these instructions for									• Auto-off Power Saving Feature
future reference.									• Operated by 2 AAA batteries
	1147-INS-LAB-RevA09	2					3			4
PREPARATION							9. When Minute digit flashes, press the“	MEMO” or “PAGE ”	3.2 Applying the Wrist Cuff
							button to select Minute. Press the“	AVG” button to	1. Place your elbow on a table with the palm facing upward.
2.1 Battery Installation							confirm.
									Wrap the wrist cuff around the left wrist as shown below.
							10. Follow the same steps to set the 2nd, 3rd, and 4th Alarm.
1. Remove the battery cover in the									2. Pull on the end of the cuff until it wraps securely around
							Note:
direction indicated on the cover.		5. “ON” and “OFF” will then flash.This is to have the clock							your upper wrist. Do not over tighten the cuff. Allow 1-2
							- Press the “ ” button anytime during clock setting/alarm		cm or ½ inch between the bottom of the cuff and your
		display when the unit is not in use; you can choose
							setting to start over if an error occurs.
2. Insert 2 AAA batteries with the									wrist joint.
		Clock Function “ON” or “OFF”.Press “		MEMO” or “PAGE		”
							- Each alarm lasts 45 seconds, or you can turn it off by
polarities as indicated.		button to select. Press the “	AVG” button to confirm.						3. Make sure the cuff is at the same level as your heart.
							pressing the “ ” button.
		Note: If you select Clock Function “ON”, you will continue at
3. Slide the battery cover back to		the Alarm Setting section. Otherwise, setting will end.					TAKING A MEASUREMENT
close it.The cover will click into		2.3 Setting the Alarm
place when completely closed.							Note:
		Note:
									3.3 User Setting
							- Avoid smoking, eating or exercising for 30 minutes before
		- You will not be able to set alarm clock if Clock Function
Note：Replace batteries when the battery indicator “ ”							taking a measurement.		This unit allows a maximum of 4 users to store measurement
		is set to “OFF”.
							- Do not move or talk during measurement.		records in different User Pages.
shows low voltage.		- You can set a maximum of 4 alarms.
							- Measurement can be taken on either arm; however, if
2.2 Setting the Date and Time									Press ”PAGE ” button to switch between User Page 1 ,2, 3 and 4.
							possible, always take measurements on the left arm.
Note:							3.1 Sitting Correctly		3.4 Taking A Measurement
- Set the correct date and time before taking a
							1. Relax.		1. Press the “ ” button.The cuff will automatically inflate
measurement.
							2. Sit upright in a chair with your feet on		and the measurement will start.
- Reset the date and time after replacing the batteries.
		6. To disable Alarm, Press the ”	MEMO ” or “PAGE		” button		the floor.		2. When the measurement is complete, the cuff will
1. Press and hold the “ AVG” button for a few seconds until
		to select “OFF” and press the ” AVG” button to confirm.					3. Remove thick or tight-fitting clothing		automatically deflate and your systolic and diastolic
the Year display flashes.
		7. To set 1st Alarm, Press the”	MEMO” or ” PAGE		” button to		from the lower arm. Do not roll up		pressure values and pulse rate will display.
2. Press the“ MEMO” or “PAGE ” button to select the current
		select “ON”. Press the ” AVG” button to confirm.					your sleeve if it is too tight.		3. Remove the wrist cuff and take note of your measurement
year.
		8. When Hour digit flashes, press the“		MEMO” or “PAGE		”	4. Place your arm on a table so that the		results.
3. Press the“ AVG” button to confirm Year Setting.
		button to select Hour. Press the“		AVG” button to			cuff wil be at the same level as your		Note:You can press the “	” button to stop measurement at
4. Follow the same steps to set the Month, Date, Hour and
		confirm.					heart.		any time.
Minute.
	5	6					7			8

SIZE:72*97MM

3.5 Heartbeat Readings

Besides Systolic and Diastolic values, Pulse will also be displayed after a measurement

Pulse

Irregular Heartbeat

This unit has a unique feature that alerts user of irregular heartbeat detection during measurement.

Note: An irregular heartbeat is defined as a heartbeat rhythm that has a variation of more than 25% from the average rhythm detected during measurement.

If an irregular rhythm occurs twice or more during the same measurement, the monitor will display the pulse value and “IH” symbol alternately. Example: (90 / IH)

Note: Please consult your doctor if irregular heartbeat occurs often.

Regular but Below Normal Heartbeat

If the monitor detects a pulse rate below

58 beats per minute during measurement, the monitor will display the pulse value and “LO” symbol alternately. Example: (58/LO)

9

TROUBLESHOOTING

Symptom	Possible Cause	Solution
No display when	Batteries are worn	Replace with new batteries
you press the	out
	Battery polarities	Re-align batteries in correct
Power/Start button
	are incorrect	polarities
“Err P” displays	Failure to inflate	Ensure the cuff is properly
		connected
“Err 1” displays	Deflating too rapidly	Return for service
“Err 2” displays	Movement during	Do not move during
	measurement	measurement
	Signal interference	Remove interfering source,
		e.g. mobile phones, magnets
“Err 3” displays	Incorrect results	Measure again

Note: If your problem cannot be solved by the above, consult a GF Health Products, Inc. representative. DO NOT disassemble the unit.

STORAGE & MAINTENANCE

Keep away the unit from direct sunlight, extreme temperatures, humidity or moisture.

Use a dry or slightly water-dampened cloth to clean the unit.

Do not use alcohol, benzene, thinner or other volatile liquids to clean the unit.

13

Regular but Above Normal Heartbeat

If the monitor detects a pulse rate above 100 beats per minute during measurement, the monitor will display the pulse value and “HI” symbol alternately. Example: (102/HI)

3.6 WHO Light Indicator

This unit features a 6-color LED light indicator to display blood pressure level in accordance with the WHO (World Health Organization) classification.

mmHg

	110	Grade 3 hypertension(severe) (Red)
	105	Grade 2 hypertension(moderate)
Pressure		(Yellow)
	100	Grade 1 hypertension(mild)
Diastolic	95	(Purple)
	90

High- normal(Green)

85 Normal

80(Sky Blue) Optimal(Blue)

120 130 140 150 160 170 180mmHg

Systolic Pressure

10

Do not wash the wrist cuff or expose it to liquid.

Remove the batteries from the unit when it will not be used for more than 3 months.

SPECIFICATIONS

Model No.	1147
Measurement Method	Oscillometric
Measurement Range	Pressure: 20 – 280 mmHg
	Pulse Rate: 40 – 195 beats/min
Accuracy	Pressure: +/- 3 mmHg
	Pulse Rate: +/- 5%
Inflation	Pump driven
Pressure Detection	Semi-conductor
Power Supply	2x AAA batteries
Auto Power Off	3 minutes after last operation
Storage Environment	-4°F to 140°F, 10% to 95% RH
Operation Environment	50°F to 104°F, 30% to 85% RH
External Dimensions	3.15” (L) x 3.35”(W) x 2.36” (H) or
	80 x 85 x 60 mm
Net Weight	140g (batteries excluded)
Cuff Dimensions	Wrist circumference of 135~220mm
Package Contents	Blood Pressure Monitor,
	Instruction Manual, Batteries

Note: Specifications are subject to modification without prior notice.

14

WHO Classification	Color			4.2 View Average Readings
Optimal -----------------------Blue					1. Press the “				AVG” button to enter Average function.
Normal ------------------------Sky Blue
			Kpa		2. If the User Page is not what you want to view, press the
High-normal -----------------Green					“PAGE ” button to select.
Mild hypertension ----------Purple
					3. Press the “				AVG” button to view different Average Values.
Moderate hypertension ---Yellow
					5 different Average Values are available:
Severe hypertension -------Red
		WHO Light Indicator			Symbol on Display						Average Values of
Example: If your measurement reading is 122/75, the LED light					1 h						One Hour
will display the color in blue.					1 d						One Day
					7 d						One Week
MEMORY FUNCTIONS					30 d						One Month
						ALL					All Readings
After measurement, the last set of measured values will be
saved automatically after measurement when the unit is				4.3 Delete Past Readings
turned off by pressing “	” button or by automatic power-off
after 3 minutes.					User can delete all the past readings stored in each User
4.1 View Past Readings					Page.
					1. Press the “PAGE ” button to select the User Page you want
1. Press the “ MEMO” button to enter memory function.
					to delete.
2. If the User Page is not what you want to view, press the
“PAGE ” button to select.					2. Press and hold the “					MEMO” & “PAGE ” buttons
3. Press the “ MEMO” button to display the next sets of					simultaneously for 5 seconds. Symbol of “ALL EE” will be
values for the user selected. Past readings are					displayed and all past readings stored in that User Page
displayed from the most recent to the oldest.					will be deleted.
4. This blood pressure monitor can store up to 99 sets of
past readings for each user (4 x 99).
	11									12
LIFETIME LIMITED WARRANTY
GF Health Products, Inc. offers a lifetime limited warranty
on defects in material and workmanship for this product,
except as noted below:						GF Health Products, Inc.
This product warranty does not cover damage caused by
						2935 Northeast Parkway
misuse or abuse, the attachment of any unauthorized							Atlanta, Georgia 30360
accessory, alteration to the product, or any other
					telephone: 800-347-5678, 770-447-1609
conditions whatsoever that are beyond the control of
					fax: 800-726-0601, 678-291-3232
GF Health Products, Inc. GF Health Products, Inc. shall
not be responsible for any type of incidental,
consequential, or special damage.
To obtain warranty service on your Lumiscope
Blood Pressure Monitor, please contact the Repair
Department at 1-800-672-8293. There is a $15 fee for
return shipping and handling. Please make checks payable
to GF Health Products, Inc.								www.grahamfield.com
Upon receipt, we will repair or replace, as appropriate,
the Blood Pressure Monitor and return it to you. This					© December 2009 GF Health Products, Inc.
warranty does not include any labor charges incurred in
									Made in China
replacement part(s) installation or any associated freight
or shipping charges to GF Health Products, Inc.
Warranty is solely through the Repair Department.
Service of this product by anyone other than the Repair
Department voids warranty.
	15