3.0CONNECTING THE SNOWBLOWER TO THE TWO WHEEL TRACTOR

1.Install the Quick Hitch Pin Kit as shown in figure 3.0-1.

1 -Quick Hitch Pin

2 - Bolt

3-Attachment Adapter

4--- Bushing

Figure 3.0-1

2.Put the bushing on the 1/2" x 2-3/4" Bolt and fasten to the upper, left quick hitch stud as shown in figure 3.0-1.

3.Apply multi-purpose grease to the quick hitch pin and power take-off (PTO) shaft on the tractor.

4.Put the universal joint on the snow- blower drive shaft as far as it will go.

5.Move the tractor putting the quick hitch pin three and one half inches into the snowblower support.

6.Put the other end of the universal joint on the PTO shaft of the tractor.

7.Move the tractor putting the quick hitch pin all the way through the snowblower support.

8.Put the ring pin through the hole in the end of the quick hitch pin as shown in figure 3.0-2.

1 - Ring Pin

2-Snowblower Support

3-Universal Joint

Figure 3.0-2

To remove the snowblower from the tractor, remove the ring pin. Separate the tractor and snowblower and keep the universal joint with the snowblower.