GB - 14
ADJUSTING DIRECTION CONTROL PEDAL
1. Remove jam nut from stop bolt and remove stop
bolt from frame.
2. Remove bolt and nut connecting rod end to
direction control pedal.
3. Turn rod end farther onto rod to angle pedal back.
Turn rod end farther off of rod to angle pedal
forward.
4. Check that pedal is in a comfortable position. Adjust
again if necessary.
5. Replace bolt and nut removed in step 2.
6. Reinstall stop bolt and turn adjustment nut until
pedal hits bolt when fully depressed forward.
7. Reinstall jam nut on stop bolt and tighten.
ADJUSTING PARKING BRAKE
To test parking brake:
1. Engage parking brake, shut off engine and remove
key.
2. Disengage transmission. See Moving Unit Manually
in Operation.
3. Push unit. If unit can be moved, adjust parking
brake.
To adjust parking brake:
1. Adjusting Bolt
2. Plate Bolt
3. Notch
4. Neutral Switch
5. Neutral Bracket
Figure 7
1
2
3
4
OF3350
5
1. Control Pedal
2. Stop Bolt
3. Adjustment Nut
4. Jam Nut
5. Rod End
123
4
5
Figure 8 OF3360
1. Loosen jam nuts.
2. Tighten adjustment nuts
to eliminate slack in
cables.
3. Tighten jam nuts against
cable bracket.
Figure 9 OF3341