Installation Recommendations
Install the Fan - continued
3.Slide ductwork over the fan’s discharge collar and securely attach it with sheet metal screws. Make sure the screws do not interfere with damper operation. Check damper to make sure it opens freely.
Wire the Fan
1.Remove wiring cover. If fan/light combination is being used, make sure the fan plug is connected to the fan receptacle and the light plug is connected to the light receptacle, shown in Fig. 8. Using proper wire connectors, wire the fan as shown in Fig. 9a. For wiring of light proceed to Fig. 9b.
| Fan |
| Light |
| Fan Outlet (top) |
| Fig. 8 | Light Outlet (bottom) |
Fig. 9a
Fig. 9b
115 & 277 Volt
Black wire is “Hot” White wire is “Neutral” Green wire is “Ground”
220 - 240 Volt
Black wire is “Hot”
White wire is “Hot”
2. Push all wiring into the unit’s cover and replace wiring cover.
Green wire is “Neutral/Ground”
Attach the Grille
1.If lighted grille is being used, plug wire into fan socket.
If lighted grille and ceiling radiation damper are being used, plug wire from lighted grille into ceiling radiation
damper socket. Do not plug wire directly into the fan socket. Make sure the wire does not interfere with the ceiling radiation damper operation.
2. Attach grille with two screws provided. Make sure not to over tighten, over tightening will damage grille.
3. | Slide attachment screw covers over the attachment | Fig. 10 |
|
|
|
|
| ||
| screws, shown in Fig. 10. |
|
|
|
4. | If lighted grille is being used, install light bulb(s) into light socket(s). For incandescent |
|
| |
| lights, use maximum 100 watt bulb (by others). For fluorescent lights, use only |
|
| |
| Greenheck’s Part Number 382854, provided, 13 watt flicker resistant light bulbs. For |
|
| |
| replacement bulbs please contact Greenheck at phone number | Squeeze tabs to | Fig. 11 | |
|
|
| insert/remove lens |
|
5.If lighted grille is being used, snap lens into place, by pushing on the outside edges
of lens, shown in Fig. 11. To remove lens, use small screw driver and pry on one side of lens.
6.Turn on power and check fan and light operation.
General Maintenance Suggestions
Model SP/CSP ceiling exhaust fans require very little maintenance. But since small problems over time left unchecked could lead to loss of performance or early motor failure, we do recommend that the unit be inspected periodically (once or twice a year).
The fan motor and wheel should be checked for dust and dirt accumulations. Dirt buildup can lead to loss of performance and motor overheating. Cleaning can be accomplished by brushing off any dust that may have accumulated. Even filtered units can accumulate
The motor should be checked for lubrication at this time. Lubricate only those motors which have an oil hole provided. A few drops of all purpose oil (SAE 20) will be sufficient.
Warranty
Greenheck warrants this equipment to be free from defects in material and workmanship for a period of three years from the purchase date. Any units or parts which prove to be defective during the warranty period will be replaced at our option when returned to our factory, transportation prepaid.
Greenheck will not be responsible for any installation or removal costs.
GREENHECK | SP/CSP models shown are | ||
| P.O. BOX 410 SCHOFIELD, WISCONSIN | UL and cUL listed E 33599 | Rev 8 March 2004 |
® | PH. | ||
www.greenheck.com |
| Copyright © 2004 Greenheck Fan Corp. | |
