Tips for THE Assembly of your new Mantel
•Before you begin assembly, locate the instructions and hardware. Take out all the parts and compare them to the diagrams below. Be sure you have all the parts and can identify them.
•A helping hand is always good. Assemble your mantel with an adult assistant if possible. Some pieces are heavy and will need to be held by a helper. Assembly time will take approximately
INSIDE | OUTSIDE |
VIEW | VIEW |
TOP 1PC
CHERRY: ZZ.2808CHG.08
BASE 1PC
CHERRY: ZZ.2808CHG.01
LEFT front | LEFT side | RIGHT front | RIGHT side |
panel 1PC | panel 1PC | panel 1PC | panel 1PC |
CHERRY: | CHERRY: | CHERRY: | CHERRY: |
ZZ.2808CHG.05 | ZZ.2808CHG.03 | ZZ.2808CHG.04 | ZZ.2808CHG.02 |
Upper Facing PANEL 1PC
CHERRY: ZZ.2808CHG.06
FIREBOX SHELF 1PC
CHERRY: ZZ.2808CHG.09
LOWER FACING PANEL 1PC
CHERRY: ZZ.2808CHG.07
|
|
|
|
|
|
|
|
|
|
| 17PCS | 17PCS |
| 2PCS | 2PCS | 4PCS | 4PCS | 4PCS | |
|
|
|
|
|
|
|
| ||
WINGNUT AND LOCK WASHER |
|
|
|
1
Get Ready to Start
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
Step 1 | Step 1 |
Locate the base and place it on the floor. Do not put it up against the wall at this point in the assembly, as you need to get in behind the mantel to insert several wingnuts, lock washers and firebox screws.
Step 2 | Step 2 |
Locate the left side panel and the left front panel. Facing the front of the base, take the left side panel, positioning it so the holes in the blocks on the bottom line up with the holes on the base. Position the left front panel next to the left side panel, lining up the holes in the blocks with the holes on the base. Attach the left front and side panel to the base by inserting and tightening 1 wingnut and 1 lock washer to each piece. Attach the left side and front panels together by inserting and tightening 2 wingnuts and 2 lock washers.
Step 3
Repeat Step 2, but with the right side panel and the right front panel.
Step 4 | Step 4 |
Locate the lower facing panel and
the firebox shelf. Attach the lower facing panel by placing the finished side to the front then line up the holes on each side and insert 1 wingnut and 1 lock washer into each. Place the firebox shelf in behind, right up against the lower facing panel.
Step 5 | Step 5 |
Locate the upper facing panel that will be attached to the left and right legs and will sit above the firebox. Position this panel with the finished side facing the front of the mantel. Line up the holes on each side and insert and tighten 1 wingnut and 1 lock washer on each side.
2