G1022 Series Table Saws -23-
Figure 18. Installing the motor mount bracket.
Figure 19. Attaching motor to linking bars.
6. Line up the hole in the motor bracket with the
hole in the motor mount plate and insert the
motor pivot rod. Make sure the groove in the
rod lines up with the setscrew in the mount
bracket.
7. Tighten the setscrew.
8. Turn the arbor tilting handwheel until the
arbor is set to 0°.
9. Slide the motor assembly onto the linking
bars through the holes in the motor bracket
as shown in Figure 19.
10. Line up the setscrews with the grooves on
the linking bars and tighten them.
Figure 20. Attaching the V-belt to the motor.
11. Lift the motor up and slip the V-belt over the
grooves in the pulleys. Slowly release the
motor, allowing its weight to add tension to
the V-Belt as shown in Figure 20.
Motor Mount Plate
Linking Bars
Motor Mount Bracket
Figure 21. Checking V-belt alignment.
12. Place a straightedge across the arbor pulley
and the motor pulley. The straightedge
should run across both pulleys evenly as
shown in Figure 21.
13. If the motor needs to be adjusted, loosen the
mounting bolt tightened in Step 4.
14. Adjust the motor on its mount until the pul-
leys are aligned, then tighten all the mount-
ing bolts.
!
!