Grizzly G0561 Blade Selection, Blade Guides, Cutting Fluid System, E C T R O C U T I O N

Blade Selection

The Model G0561 uses 93" x 3⁄4" bandsaw blades.

Selecting the right blade for the job depends on a variety of factors, such as the type of mate- rial being cut, hardness of the material, machine capability, and operator technique.

We suggest you do some research for your spe- cific situation so you get the best blade to match your needs.

Grizzly is proud to offer a variety of selections that can be found in the current catalog and in SECTION 5: ACCESSORIES on Page 28.

Blade Guides

The blade guides should be as close to the workpiece as possible. This will help ensure straight cuts by keeping the blade from twisting and drifting off the cut line.

Cutting Fluid System

E L E C T R O C U T I O N
HAZARD! Never	plug or
unplug machine with wet
hands or while	standing
on wet floor.

This bandsaw has a built-in cutting fluid system that extends the life of your bandsaw blades by lowering the cutting temperature and washing away chips.

See Cutting Fluid on Page 25 for more informa- tion.

To use the cutting fluid system:

1.Thoroughly clean and remove any foreign material that may have fallen inside the res- ervoir during shipping.

2.Place the filter screen and drain tube in the

reservoir as shown in Figure 28.

To adjust the blade guides:				3. Fill the reservoir to the "High" mark with your
1.	Loosen the knob shown in Figure	27	and	chosen cutting fluid solution.
	slide the rear blade guide as close to the
	workpiece as possible, then tighten		the	Drain
	knob.
				Tube	Filter Screen
	Blade Guides
						High
					Pump Toggle
	Knob				Switch	Low

Figure 28. Filter screen and hose.

Figure 27. Blade guides.

-24- G0561 7" x 12" Metal-Cutting Bandsaw