![](/images/new-backgrounds/1259379/25937941x1.webp)
Inside Sanding
To sand or grind an interior work area, the sand- ing belt must be fed through the workpiece and remounted on its rollers. Depending on your application, you may either remove the platen or keep it in place.
1.Remove the Belt Sanding Table and the Belt Guards.
2.Feed the Sanding Belt through the work- piece and over the Upper Idler Roller. Loosen the Small Upper Idler Roller, swing it toward the front of the machine, and feed the belt around the pulley.
3.Press down on the top arm and feed the remainder of the belt through the rollers as shown in Figure 21.
4.Replace guards and table.
5.Adjust belt tracking as described in
Adjustments section.
Figure 21. Belt arrangement for inside sanding.
Sharpening
Tilt the table to the desired sharpening angle and secure it. Using
Figure 22. False table for sharpening support.
|
|
|
|
G1013 Combination Sander |