Model g5791/g5792 17-piece 1 2" impact Wrench and ratchet Kit -5-
daily maintenance
your im pact wrench and ratchet Must
have 2-6 drop s of oil directly dropped
into the air fit ting before each use. in
addition, we recommend using an i n-line
filter, lubricator, and regulator, as shown in
figure 2 or the included in- line lubricator.
if an in-line lubr icator is not us ed, add 2-3
drops of oil int o the tool a ir inlet every 2
hours of continued use.
these p rocedures should be done
after each use:
Before putting the impact wrench or
ratchet away, put 2-6 drops of oil into
the air supply fitting and momentarily
operate the tool to distribute the oil
inside.
Wipe the tool exterior and sockets with
a slightly oiled cloth. your goal is to
leave a light film of oil on the tools to
prevent rust.
figure 3. impact wrench control locations.
torque setting
rotation Button
impact Wrench
your new 12" drive impact wrench (figure
3) generates up to 260 ft /lbs. of torque.
only use thick-wall ed impac t socke ts
with this air to ol. the commo n thin-walled
chrome so ckets m ay explod e if used as
impact sockets, causing s erious injury.
At the end of the handle you can adjust the
torque setting by pushing the knob in and
turning the knob to 1, 2, 3, or 4; 1 is t he
lowest torque setting.
to change the impact rotation, push the
slide b utton toward the front of the gun
for clockwi se rotatio n and to the rear for
counterclockwise rotati on.
ratchet
your new ratchet (figure 4) generates up
to 50 ft/lbs. of torque and deliver s up to
160 rpM.
to change the rotation, adjust the forward /
reverse dial, as shown in fig ure 4.
figure 4. ratchet locations.
Forward/reverse dial