Grizzly G7148 instruction manual Operation, Using The Slip Roll, Forming Wires

SECTION 6: OPERATION

Keep loose clothing rolled up and out of the way of rollers and keep hair pulled back.

Using The Slip Roll

Wear safety glasses dur- ing all operations on the slip roll. Failure to com- ply may result in serious personal injury.

Forming Wires

1.Perform all adjustments as required by the material thickness and whether you are engaging in straight rolls or cones.

2.Insert material edge between the fixed shaft and the front movable shaft.

3.Turn the handle to process the material.

4.If you are only performing partial rolls and need to remove the material, slide out release rod shown in Figure 2 and pull the fixed shaft forward. You can now remove the material from the slip roll.

Shaft

Release

Rod

Figure 2.

1.To form wires, select the smallest groove that you can use (see grooves shown in Figure 3) and put the edge of that wire on the groove of the front movable shaft.

2.Turn the handle to process the wire.

3.If you are only rolling part of the wire, slide out the release rod and pull the fixed shaft forward. You can now remove the wire from the slip roll.

4.If you want to form rings from wire, process the wire until the end meets the length of the stock. Remove the fixed shaft and cut the wire where the end meets it.

Figure 3. Wire grooves.

-4- G7148 12" Slip Roll