To operate this, or any power tool, safely and efficiently, it is essential to become as familiar with its characteristics as possible. The time you invest before you begin to use your Model G9247 will be time well spent. DO NOT operate this machine until you are completely familiar with the contents of this manual. Make sure you read and understand all of the safety procedures. If you do not understand something, DO NOT operate the machine.
OPERATING TIPS
1.Make sure cutting tools are sharp and clean for best tool performance and safe operation.
2.To avoid accidental starts, make sure the Speed Control knob is set at “0” before plugging in the elec- trical power cord.
3.If any part of the Mini Wood Lathe becomes damaged during use, turn off the power immediately. Do not proceed with using the lathe until the problem area has been investigated and corrected.
4.Never leave the working area until the lathe has been turned off and the spindle has come to a com- plete stop.
5.Once a workpiece has been clamped onto the lathe, always rotate the workpiece by hand and check for proper tool rest clearance before turning on the electrical power.
6.When turning a workpiece, always rough the wood to round form at a low speed to reduce the risk of workpiece kickback.
7.Always position the Tool Rest above the centerline of the workpiece when shaping a piece of stock.
8.Note the Directional Arrow label (#25). Do not operate the Mini Wood Lathe if the Spindle is rotating in the wrong direction.
9.Remove all loose knots in the stock before it is mounted on to the lathe.
10.Always keep a firm hold on and maintain control of the cutting tool.
11.If you are uncertain about the optimal speed, it is better to start with the slowest RPM and increase your speed as your comfort with the tool and the work piece increases.
12.Never force the tool or attachment to do the work of a larger industrial tool. It is designed to do the job better and more safely at the rate for which it was intended.
REMOVING THE SPUR AND CUP CENTERS
1.Insert a pin into the Spindle (#28) hole and turn the hex nut counterclockwise with a wrench until the Spur Center (#30) is ejected.
2.Turn the Hand Wheel (#63) counterclockwise until the Cup Center (#46) can be removed.
G9247 Mini Wood Lathe |
