OPERATION
Operating this tool can propel objects into the air, causing immedi- ate eye damage. To protect yourself, always wear American National Standards Institute (ANSI) approved safety glasses or goggles when oper- ating this equipment.
OPERATION
1.Before using the Flexible Shaft Grinder, determine a location in the work area to mount the Holder and the Hanger. Drive (2) wood screws through (2) Electrical Rings and through the Hanger to the mounting location selected. Attach the Hanger to the Motor Housing with (2) screws.
2.The Flex Shaft and Flex Shaft Housing need to be lubricated with a light lithi- um lubricant or machine oil. Use only as small amount. Too much lubricant can become messy and possibly get on your workpiece. Do not use auto- motive grease as it is too viscous.
3.A setscrew holds the Flex Shaft to the Motor Shaft. When the Flex Shaft is secure to the Motor Shaft, thread the end of the Flex Shaft Housing onto the base of the Motor Housing. Be sure that the Flexible Shaft assembly is not bent more than 90 degrees or kinked.
4.The Grinder Head fits onto the end of the Flex Shaft. It is secure when you hear a snap. To remove the Grinder Head from the Flex Shaft, firmly grasp the Grinder Head and Flex Shaft with two hands and pull apart.
Under normal working conditions and use, it is normal for the Motor Housing to become hot. However, the hot surface may cause personal injury if touched or present a possi- ble danger of an extreme fire hazard if near flammable material. If the Flexible Shaft Grinder is used for a prolonged period of time and the motor housing becomes EXTREME- LY HOT, stop using the machine and let it cool down.
5.Loosen the Drill Chuck with the Chuck Key. Insert the desired bit and tighten the Drill Chuck with the Chuck Key.
6.Attach the Foot Control as follows. Insert the Plug into the Female Plug. Insert the Power Plug into the electri- cal outlet. The depth of the Foot Control can be set by using the setscrew on the Foot Control, this will allow the operator to adjust for desired maximum speed. Tightening and low- ering the screw will allow for greater speeds. Loosening and raising the screw will limit the speed allowed by the Foot Control.
7.Make sure all safety instructions have been followed before turning the machine “ON”.
8.Once the tool is on, select the desired speed by using the Foot Control.
G9928 Flex Shaft Grinder
